Baffles
Baffles and secondary air tubes that sag, crack or burn through are replaced which cuts smoke and creosote.
A wood stove that smokes into the room, burns through wood too fast or will not hold a fire usually has a worn gasket, a damaged baffle or a draft problem, and a technician in Sharon can repair it. Call (724) 509-7140 to be connected with a nearby stove technician.
The whole point of a closed stove is controlled air, which is why worn seals cause so many problems. Too much air from leaky seals means a fire that roars through fuel, and too little draft means smoke, sooty glass and a fire that sulks.
Firebrick, baffles and air tubes are the stove parts that wear with use. Cracked firebrick exposes the steel, a warped baffle sends smoke up the flue unburned, and a worn catalytic combustor stops cleaning the exhaust. Parts are usually ordered by model, so look for the label on the back or side of the stove.
Signs of overfiring deserve attention before the next fire. A glowing red stovepipe or stove top, warped plates or cracked castings mean the stove has run hotter than it was built for. Have it inspected before using it again, and if a chimney fire ever starts, get everyone out and call 911.
Many wood stove repair calls in Sharon also turn up a need for wood stove installation or creosote removal.
Need wood stove repair in Sharon? Call (724) 509-7140 and describe the problem to a chimney sweep who works in Sharon.
Call nowA stove repair starts with finding out why it misbehaves, not just swapping parts.
The technician asks how the fire starts, burns and dies down, and what fuel is used. Fuel moisture is often part of the answer.
Door and glass gaskets, latch, firebrick, baffle, air tubes and castings are checked one by one. On catalytic stoves, the combustor is checked for clogging and crumbling.
The stovepipe and chimney are checked for creosote, blockages and loose joints. Sometimes the stove is fine and the flue is the fix.
New gaskets, ceramic glass, firebrick, baffle boards or air tubes are installed to fit the model, including stove-rated ceramic glass, never ordinary glass.
A burn test checks the seals, the draft and the response to the air control. Ask how often to check gaskets and firebrick going forward.
Baffles and secondary air tubes that sag, crack or burn through are replaced which cuts smoke and creosote.
Cracked or broken glass is replaced with ceramic glass cut for the stove and sealed with a fresh gasket.
Worn or clogged combustors in catalytic stoves are cleaned or replaced to bring smoke output back down.
Cracked, crumbling or missing firebricks are replaced to protect the steel or cast iron.
Door and glass gaskets are replaced with the correct rope size to restore control of the fire.
A proper wood stove cleaning reaches every place soot and creosote collect, from the firebox to the chimney top. The baffle is lowered so the space above it can be cleared, the connector pipe is brushed or taken down, and the flue is swept. Creosote comes in stages, from dry flaky soot to tar-like and glazed deposits, and the heavier stages need more than a brush.
For Sharon homes that burn regularly, the NFPA 211 standard calls for a yearly inspection, with sweeping as needed. A common rule of thumb is to sweep when deposits reach about an eighth of an inch. Between cleanings, dry wood and hot fires keep creosote down.
Around Sharon, stove repairs pile up once the burning season is in full swing, with worn gaskets and dirty stovepipes leading the list. Across Sharon and places such as Farrell, Sharpsville, Hermitage and Greenville, older steel and cast iron stoves still heat many homes, and parts for most of them can be found by make and model.
For wood stove repair in Sharon, PA or nearby towns like Farrell, Sharpsville, Hermitage and Greenville, call (724) 509-7140 to reach a chimney sweep who covers your street.
Cold winters keep fireplaces, wood stoves and oil burners working for half the year or more. Masonry takes the worst of it from the freeze and thaw cycle: rain and melting snow soak into the crown and joints, then freeze and push them apart, which is how cracks, loose bricks and leaks start. Nor'easters drive rain sideways into flashing and mortar that looked fine in summer. Most homeowners in Sharon, PA schedule a sweep in early fall, and a repair check after a hard winter.
A chimney problem fixed early rarely spreads to the masonry, the liner or the house.
Chimney sweeps in Sharon know the chimneys and fireplaces common in local homes.
Ask the sweep about the cause, the options and the estimate before work starts.
More questions? Call (724) 509-7140
Setting up a new wood stove from hearth pad to chimney cap, with stovepipe, liner or chimney sized to the stove.
Learn moreClearing stage 1, 2 and 3 creosote from fireplace and stove flues matched to how hard and thick the deposits are.
Learn moreRestoring a damaged chimney liner so smoke and gases stay sealed inside the flue.
Learn morePellet stove repair for feed, ignition and venting problems, with the burn pot, exhaust path and vent cleaned along the way.
Learn moreLooking for something else?
See all chimney servicesCall (724) 509-7140 to talk to a chimney sweep serving Sharon, PA.
Free to call. No forms to fill out.